Description of Problem 100000022355
How do I charge the battery in my pocket jet
printerDescription of Solution 200000028443
Using a Ni-MD
Any time the
printer is connected with a working Brother AC adapter or a working Brother DC
power cord the battery is being trickle charged. The procedure to perform
a charge is as follows:
1. Make sure the
printer is connected to an AC power outlet with the AC adapter and power cord or
a DC power cord.
2. Make sure the
printer is off, the power, data, and error indicators will be off
3. Press the power
button and hold it down for a few seconds until the power indicator light begins
to alternately blink green and orange. This indicates that the battery is
being prepared for a deep charge cycle. If you do not want to do a deep
cycle charge then press the power button the battery will start charging and the
power indicator will blink green until the batter is charged.
The maximum time to
completely charge a battery is approximately 120 minutes.
NOTE: To end the charge cycle before the battery is completely charged
press the power button twice quickly.
Using the Li-ion
The Li-ion battery
can be charged installed in the printer or in a standalone configuration.
The Li-ion battery cannot be trickle charged.
To charge the
1. If the
battery is connected to the printer make sure that the printer is turned
2. Use the AC
adaptor and AC power cord to connect the battery to an AC outlet or a DC cable
to connect the battery to a DC power outlet and the battery indicator will glow
orange. When the battery is fully charged the battery indicator will turn
off. The maximum time to completely charge the battery is approximately