1. Click on the link
below to download a test pattern and print the test pattern.
the printed document.
a large, continuous black or colored vertical line passes through all of the
colors, go to STEP 3.
a white vertical line passes through only one color, refer to the solution -
do I clear white vertical lines or streaks appearing on printed
a black or colored line appears in only one color, go to STEP
the corona wire on the drum unit:
off the Brother machine. The power switch is located on the lower right
- Open the machine
by pulling up on handle of the top cover until the top cover locks in place.
that the top cover is completely open. Failure to completely open the top cover
of the machine before attempting to remove or install consumables may make the
installation or removal of the items difficult or damage the machine.
- Remove the drum
unit and toner cartridge that matches the color of the line identified in
2 from the
drum unit and toner assembly can be removed by grasping the center of the drum
and toner assembly and pulling it straight up.
the drum unit and toner cartridge assembly on a piece of disposable paper or
cloth to avoid spilling and scattering the toner.
the green tab (Corona Wire Cleaner) on the drum assembly.
e. Clean the primary corona wire inside
the drum unit by gently sliding the green tab (Corona Wire Cleaner) from left to
right and from right to left along the drum approximately 7 times. Return the
green tab to the home position.
f. The corona wire cleaner should rest
on the left hand side of the drum unit (as viewed with the drum unit facing away
from you). The small triangle on the corona wire cleaner should be aligned with
the small triangle on the gray portion of the drum unit, which is also on the
left side of the drum.
g. When placing the Corona Wire Cleaner
in the home position (left side of the drum), verify that it is pushed
completely to the left side and aligned with the small triangle on the grey
portion of the drum unit.
should be no space between the left side of the drum casing and the Corona Wire
the drum unit and toner cartridge to the machine.
close the top cover of the machine. You should hear a click when the top cover
is closed firmly.
the machine on using the power switch located on the right hand side of the
the machine reaches a "Ready" status, print the document that initially
displayed the issue.
lines appear on the document, the issue is resolved.
the problem continues, go to STEP
8. Confirm that the
toner cartridge(s) that matches the line color in STEP
is a genuine Brother toner cartridge.
strongly recommends that customers use only genuine Brother drum units and/or
toner cartridges. Each Brother laser printer is designed to work at pre-set
temperatures that are matched exactly to each of our individual toner
formulations. Each individual component is designed to work with the other
to ensure quality and reliability. Using non-Brother supplies may affect the
hardware performance, print quality and machine reliability. The Brother limited
warranty does not apply to any problem that is caused by the use of third party
drum units, toner cartridges or toner.
If the toner is not
a genuine Brother toner cartridge, replacing the toner cartridge with a genuine
Brother toner may resolve the issue.
If the toner
cartridge is a genuine Brother toner cartridge and the issue is still present,
go to STEP
the problem continues and your machine is within warranty, you can locate a
Brother Authorized Service Center (ASC) in your area by clicking on the link
contact Brother Customer Service by calling 1-877-Brother (1-877-276-8437)
Monday through Friday, excluding holidays.
If your machine is out of warranty, you can locate a Brother Authorized Service
Center using the information listed above.